Basic Operations - Recordex ST4-650U Owner's Manual

BASIC OPERATIONS

Turning the IFP On
1. Plug the power cord into an AC power outlet.
2. Flip the power rocker switch on (labeled as I) to turn on the IFP. (This rocker switch is located on the back of the panel. Close to
where the power cable connects to the IFP.)
Note: Be sure to wait for a few seconds before pressing the
the rocker switch, then the IFP may not respond correctly.
Turning the IFP Off
1. Press the button again to put the IFP in standby mode.
2. Switch the power rocker switch off (labeled as O) to cut off the power completely.
FIRST TIME INSTALLATION
When turning on the IFP for the first time, you must select a language and a time zone.
Below are the pages that will appear on the screen on the first boot.
Select the desired language. Press
Next to go to the next page.
Select your Time Zone and press
Finish, this will finish the installation.
button. If you press the power button quickly after flipping
9