Basic Controls - Panasonic TH-80SF2HU Operating Instructions Manual

Basic Controls

Main Power On / Off button
(Back of the unit)
Operate pointing the remote control directly at the unit's
Remote Control Sensor.
Note
● For normal use, pull out the remote control sensor
from the edge side of the main unit by operating the
lever on the rear panel. (see page 17)
●
Do not put an obstacle between the remote control
sensor of the main unit and the remote control.
●
Operate the remote control in front of the remote
control sensor or from the area where the sensor can
be seen.
●
When directly aiming the remote control at the remote
control sensor of the main unit, the distance from
the front of remote control sensor should be approx.
7 m or less. Depending on the angle, the operation
distance may be shorter.
● Do not subject the remote control sensor of the main
unit to the direct sunlight or strong fluorescent light.
AC socket outlet
AC cord (supplied)
Remote Control Sensor /
Power Indicator
1
Connect the AC cord plug to the
Display.
(see page 14)
2
Connect the plug to the socket outlet.
Note
● Main plug types vary between countries. The
power plug shown at left may, therefore, not be
the type fitted to your set.
●
When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the
socket outlet first.
●
The settings may not be saved if the power plug
is disconnected immediately after changing
settings with on-screen menu. Disconnect the
power plug after a enough period of time. Or,
disconnect the power plug after turning the
power off with the remote control, RS-232C
control or LAN control.
3
Press the <Main Power On / Off
button> ( ) on the unit to turn the
power of the unit on.
●
Power Indicator: Green (Picture is displayed.)
●
When the power of the unit is on, the power
indicator lights up and remote control operation is
possible.
●
When the power indicator is lit, it is not necessary
to press the <Main Power On / Off button> (
on the unit. Operate the remote control so that the
power indicator turns green (picture is displayed).
■
To turn the power ON/OFF with the remote
control
To turn the power on
● When the power of the unit is on (Power Indicator -
red or orange), press the <Standby (ON/OFF) button>
( ), then the picture will be displayed.
●
Power Indicator: Green (Picture is displayed.)
To turn the power off
●
When the power of the unit is on (Power Indicator -
green), press the <Standby (ON/OFF) button> (
then the power will be turned off.
●
Power Indicator: Red (standby)
Note
●
During operation of the "Power management"
function, the power indicator turns orange in the
power off state.
●
After the power plug is disconnected, the power
indicator may remain lit for a while. This is not a
malfunction.
● Press the <Main Power On / Off button> (
unit to turn the unit off, when the power of the unit is
turned on or in standby mode.
)
),
) on the
19
English