®
V
P
P15
ISIONEER
ATRIOT
4.
Remove the feed roller.
5.
Take the new roller out of its packaging. Clean any dust off the roller before installing it.
6.
Insert the left end of the new roller assembly into the hole in the roller channel. Angle the roller module into
the roller channel.
7.
Slide the roller to the right.
The roller will slide into place when it is aligned correctly. However, if it does not slide all the way into the
housing, rotate the roller until it does.
54
M
AINTENANCE
S
U
'
G
CANNER
SER
S
UIDE