Table of Contents
Advertisement
INSTALLATION NOTES
1.
NORMALLY POWER FROM HDMI WILL BE SUCCICIENT TO POWER TX
The Tx needs 500-1000 milli-amps (mA) to operate. Laptops are only obliged to provide
55mA through the HDMI port but they often provide more.
2.
IF NOT USE USB CABLE TO GET SUPPLEMENTARY POWER FROM A USB PORT
Use USB cable provided. It WILL NOT work with cheap USB cables
3.
IF THAT'S STILL NOT ENOUGH AN EXTERNAL POWER SUPPLY IS INCLUDED.
DISPLAY SLEEP
The Rx will stop outputting HDMI if no source is present for 10 minutes. This allows the display
to go to sleep when the source is off.
FREQUENCY SPECTRUM
This product uses 5GHz WIFI channels so it can be affected by outside interference in the same
way as any wifi device.
IR PASSBACK
If using a source device which has a remote control, this product allows the remote to be
pointed at the display in the remote location. The IR signal is relayed from the Rx to the Tx to
the source device.
To make this happen the IR blaster and receiver cables mush be used.
The diode on the blaster must be as close as possible to the source IR receiver.
•
The diode on the receiver must be in line-of-sight of the remote control.
•
TC-HDMIW30_manual_en.doc
6
Advertisement
Table of Contents
