Connecting N-Gen To Desktop Pc; Start - N-Gen INT-910H Quick Manual

3. Connecting N-GEN to desktop PC

A USB cradle of N-GEN supports charging and USB connection.
Connecting step of USB cradle of N-GEN is as following.
1. Connect charger to USB cradle.
2. Connect charger to power source (to wall)
3. Connect USB cable of USB cradle to USB port of desktop PC
4. Place N-GEN onto docking cradle then execute Synchronization with Desktop PC

4. Start

This section explains to start N-GEN when first time use
Follow the below step
1. Attach the battery to N-GEN.
2. Connect the battery charger.
3. Click reset button (soft reset)..
Before N-GEN is executing in first time, make sure to charge the battery fully. Light
clicking of reset button by stylus pen will initiate N-GEN to connect battery power source.
After 4-5 seconds later, N-GEN goes to hard rest mode that will load images from flash
Rom to SDRAM. Window logo and process bar will be popped up confirming loading status.
If main screen is fully loaded, N-GEN is ready to use.
9