8. PARAMETER MENU
The PARAMETER MENU allows you to further customize the flight characteristics of the helicopter and the reaction of the system to
control inputs. You can find a detailed description for each parameter in the MICROBEAST PLUS instruction manual.
Entering PARAMETER MENU
Press and hold button
Operation mode
blue
Menu point A - Swashplate quick trim (Menu LED A flashing)
Move the stick(s) for aileron and elevator to trim the swashplate into the desired direction. With rudder you can trimm the collective up/
down. When using the tail gyro in Normal-Rate mode you can trim the rudder servo with the rudder stick. To delete all trimming push
and hold the button for at least 10 seconds.
Menu points B to K
Color and state of the Status LED indicate which option is currently selected at each menu point. By pushing the rudder stick repeatedly
you can cycle through the available options at each menu point and change the setting if necessary. Briefly pushing the button will skip
to the next menu point. After the last menu point the system will exit PARAMETER MENU and change back to operation mode.
Status LED
Control style
B
Speed flight stability
C
Rudder rate consistency
D
Stick deadzone
E
Torque precompensation
F
Cyclic response
G
Pitch boost
H
Throttle response
I
Slow rampup speed
J
Fast rampup speed
K
(Status LED is
or
purple)
off
custom
custom
custom
custom
custom
custom
custom
soft
custom
custom
Release button
Menu LED A flashing
purple
flashing red
normal
sport*
very low
low
very low
low
very small
small*
off
low - nor.
slightly
normal*
increased
off*
low
slightly
normal*
increased
50 rps
100 rps
using slow
300 rps
rampup speed
Menu LED A flashing
(= PARAMETER MENU A)
red
flashing blue
pro
extreme
medium*
high
medium*
high
medium
large
high - nor.
low - inv.
increased
aggressive
medium
high
increased
aggressive
200 rps*
300 rps
500 rps*
700 rps
blue
TX mode
very high
very high
very large
high - inv.
very
aggressive
very high
very
aggressive
400 rps
900 rps
Need help?
Do you have a question about the MICROBEAST PLUS and is the answer not in the manual?