Playing Audio From A Bluetooth Device - Denon DN-700AVP User Manual

Assigning Sources to the Input Connectors
This screen appears when the Input Setup ► Each Input Source ► Input Assign menu is selected. Use the Input Assign
menu to route the HDMI inputs, digital inputs, and component inputs to the different sources.
1. If DN-700AVP is powered off, press the Power button to power it on.
Press the Menu button on the remote control. Use the , ,◄, ► buttons to navigate to the Input Setup ► Each Input
2.
Source ► Input Assign menu.
Use the , ,◄, ► buttons to move to the source you want to set.
3.
Press Enter, then use cursor ◄ and ► buttons to select the input to be assigned.
4.
5. Press Enter to save the setting.
Notes:
•
The default HDMI connector assignments/source numbers can be seen on the rear panel. These HDMI connectors can be
reassigned to different input sources. For example, the Blu-ray source which is assigned to (5) BD by default can be
reassigned to input (2) Game 2 from the Input Assign menu.
•
An input source to which an HDMI input connector cannot be assigned will be seen as – – –.
•
To play the video signal assigned at HDMI combined with the audio signal assigned at Input Assign ► Digital, select
Digital in the Input Mode.
•
When HDMI Control is set to On, the HDMI input cannot be assigned to TV.
Using the Dock Audio Inputs for Media Playback
1. If DN-700AVP is powered off, press the Power button to power it on.
2. Connect your media device to the Dock inputs on DN-700AVP.
3. Press Dock on the remote control or use the Source Select knob to choose Dock as the audio input source.
4. Start playback from your media device and adjust the source volume.
Playing Files on a USB Flash Drive
A USB flash drive can be connected to the USB port of this unit to play music and picture files. Only USB flash drives
conforming to mass
DN-700AVP, in the FAT16 or FAT32 format.
The supported file formats are: WMA (Windows Media Audio), MP3 (MPEG-1 Audio Layer-3), WAV, MPEG-4 AAC, and FLAC
(Free Lossless Audio Codec).
To play files on a USB flash drive:
1. If DN-700AVP is off, press the Power button to power it on.
2. Connect your USB flash drive (mass storage class) to the USB port.
Select Multimedia as your desired media type and use the Cursor ◄ and ► buttons on the remote control to select
3.
USB.
4. Select a file from the list displayed on DN-700AVP or your TV/computer monitor.
To move through audio files or folders, press the Cursor ◄ and ► buttons on the remote control.
Press Enter to open a folder or to select an audio file to begin playing.

Playing Audio from a Bluetooth Device

1. If DN-700AVP is powered off, press the Power button to power it on.
2. Use the Source Select knob to choose Bluetooth.
3. Press the Bluetooth button.
4. Navigate to your Bluetooth device's setup screen, find "DN-700AVP" and connect.
5. Begin to play music on your Bluetooth device.
To disconnect a paired Bluetooth device, press and hold the Bluetooth button for 3 seconds. Alternatively, use the
Source Select knob to choose another playback source and disconnect pairing.
Note: If your Bluetooth device prompts for a pairing code, enter 0000.
storage class and MTP (Media Transfer Protocol) standards can be played on
9