Maintenance; General; Engine; Engine Oil - Jacobsen Super LF 1880 Parts & Maintenance Manual

4

MAINTENANCE

4 MAINTENANCE
4.1

GENERAL________________________________________________________________

!
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine and remove key from
ignition switch to prevent injuries
Make sure the tractor is parked on a solid and level
surface. Never work on a tractor that is supported only by
the jack. Always use jack stands.
1. Adjustment and maintenance
performed by a
adjustments cannot be made, contact an Authorized
Textron Golf, Turf & Specialty Products Dealer.
2. Inspect the equipment on a regular basis, establish a
maintenance schedule and keep detailed records.
a. Keep the equipment clean.
4.2

ENGINE _________________________________________________________________

IMPORTANT: A separate Engine Manual, prepared by
the engine manufacturer, is supplied with this tractor.
Read the engine manual carefully until you are familiar
with the operation and maintenance of the engine.
Proper attention to
directions will assure maximum service life of the
engine. To order replacement engine manuals contact
the engine manufacturer.
The proper break-in of a new engine can make a
considerable difference to the performance and life of the
engine.
Note: The tractor is designed to operate and cut most
efficiently at the preset governor setting. Do not change the
engine governor settings or overspeed the engine.
During the break-in period, Textron Golf, Turf & Specialty
Products recommends the following:
4.3

ENGINE OIL ______________________________________________________________

Check the engine oil at the start of each day, before starting
the engine. If the oil level is low, remove oil filler cap and add
oil as required.
Perform initial oil change after first 50 hours of operation and
every 200 hours thereafter. See Engine Manual.
GB-16
should always
qualified technician. If
the engine manufacturer's
b. Keep all moving parts properly adjusted and lubri-
cated.
c. Replace worn or damaged parts before operating
the machine.
d. Keep all fluids at their proper levels.
e. Keep shields in place and all hardware securely
fastened.
f. Keep tires properly inflated.
3. Long hair, jewelry or loose fitting clothing may get
tangled in moving parts.
be
proper
4. Use the illustrations in the Parts Catalog as reference
for the disassembly and reassembly of components.
5. Recycle
(batteries, fuel, lubricants, anti-freeze, etc.) according
to local, state or federal regulations.
1. During the first 50 hours of operation, a new engine
should be allowed to reach an operating temperature of
at least 140°F (60°C) prior to operation at full load.
2. Check the engine oil level twice daily during the first 50
hours of operation. Higher than normal oil consumption
is not uncommon during the initial break-in period.
3. Change engine oil and oil filter element after first 50
hours of operation.
4. Check and adjust fan and alternator belts.
5. Refer to Section 6.3 and Engine Manual for specific
maintenance intervals.
If the injection pump, injectors or the fuel system require
service, contact an authorized Textron Golf, Turf & Specialty
Products Dealer.
Use only engine oils with API classification CD/CE.
Above 77°F (25°C)
32 to 77°F (0 to 25°C) SAE 20W or SAE 10W30/10W40
Below 32° (0°C)
or dispose of all hazardous materials
SAE 30W or SAE10W30/10W40
SAE10W or SAE 10W30/10W40