Table of Contents
Advertisement
Setup
Registering the unit
This procedure is not required for
devices that were included as part of a
bundle.
Before you can use the unit, it must be
registered to the hub.
You can register the unit by using the
registration buttons or the [Home
Network] app.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks slowly in green.
2
This unit:
Using an object with a thin tip, press
and hold M
N until the LED blinks
slowly (page 12).
R When registration is complete, the
hub sounds one long beep.
PLACE HOLDER
PLACE HOLDER
Note:
R To cancel without registering the unit,
press M
N on the hub and on this
unit again.
R If registration fails, the hub sounds
several short beeps.
14
For assistance, please visit http://shop.panasonic.com/support
Using the app
When you register the unit by using the
[Home Network] app, you can assign a
name to your devices and group them
by location. For more information, refer
to the User's Guide (page 20).
Confirming the
installation area
Before deciding where to install the unit,
carefully read the chapter "Installation
Location", beginning on page 8, to
confirm the installation location and
OTHER
direction.
Advertisement
Table of Contents
