Advertisement
4.INSTALLATION
Open the chassis of PTZ
camera with wrench.
Use wrench to remove the
connect board. On the back of
the board, there are two
switches.
SW1: represent the dome's
address
SW2: protocol and baud rate
setting
DIP Setting
the detail of setting, please see Page 20
Installing
Lock the classis, intalling the dome.
9
Some products may not be available in your country, please contact our distributor for more details
the bottom of
the PTZ Camera
release
connect board
Sw1 Sw2
5.OPERATING THE SPEED DOME
Initial Screen
After powering up, the camera will enter the
FIRMWARE V1.0
self-test mode and display the status screen(
Protocol: VIDO B02
as in the picture left).It contains information
Dome Address: 001
about the model and current settings.
Comm 9600,N,8,1
- V1.0:
Current firmware version
- Protocol:
control protocol which currently used
- Dome address:
Address ID of speed dome. please refer to the section "Protocol
setup " for details.
- Comm 9600,N,8,1:
current setting of the serial communication interface.
9600:
Baud rate. please refer to section "Baud-Rate setup" for details
N, 8, 1:
No parity bit, 8 bit length, 1 stop bit. this setting can not be changed
The intial screen will stay remain on until any user action is being taken. If the power-
up action is set, the initial info wil vanish immediatly.
Operation Screen
The operation screen can display additional
information.
Temperature: current temperature inside the
speed dome( C or F)
°
°
Cam title:
User definable camera title
Zone:
Current zone name
Pan deg.:
Pan angle, 0-359°
Tilt deg.:
Tilt angle, 0-90°
Zoom Factor: Zoom factor
Date &Time:
show
the cur.
date(
YY/MM/DD)
and
the cur.
time(HH:MM:SS)
Display of the information can be activate or
deactivate through the OSD menu. please refer to
the system setting for detais.
PTZ operation
For the surveillance operation, the dome can be controlled from a keyboard device
(e.g. AU-KB3N), Multiplexer or DVR through RS-485 Interface. Make sure that the
cable is connected and the settings (baud rate, Address ID and protocol) of both
keyboard and the dome are configured correctly. For more description about the PTZ
operation, please refer to the user's manual of the keyboard.
Some products may not be available in your country, please contact our distributor for more details
Temperature
CAM TITLE
10.5C
09/11/17
ZONE-1
09:32:35
285 78
18X
Zoom factor
Tilt degree
Pan degree
Zone description
10
Advertisement
