Advertisement
4.INSTALLATION
Connector description
The wiring cable of G35M series provides connectors for power supply, video and I/O
interface
Power
Connector
RS485
Connector
RJ-11
Video output
BNC
Alarm I/O 1
5
Some products may not be available in your country, please contact our distributor for more details
RED: DC 12V +
BLACK:
DC 12
V -
To power supply
Green:RS485+
Yellow:RS485-
To Keyboard or DVR decives for
telemetric control
Inner Conn: Signal +
Outer Conn: Ground
Video Output to monitor or DVR
RED: Alarm in 1
PINK: Alarm in 2
YELLOW:
Alarm in 3
GREEN:
Alarm in 4
BLACK: COM
WHITE: Alarm output - N.O
BLUE: Alarm output - N.C
I/O interface to additional alarm sensor
or control devices
Using optional accessories
The G35M series can be connected to various optional accessories through the
standard connector types, which simplifiy the cable handling and avoids possible
mistakes. All accessories are tested for max. compatibility and best performance.
DC 12V
Power input
(power from vehicle)
Video signal
RS 485 cable
The telemetric control of the appliance uses Rs485 serial communication with half-
duplex transmission technology.
Depends on the cable typeand baud rate, the transmission distance could vary. The
following table shows max. distances based on cable with 0,56mm (24AWG) twisted
pair:
Due the environmental interferences, such as
Baud Rate
Max. Distance
eletromagnetic and induction fields, or number of
1700m
2400 bps
connected appliance on the RS-485 bus, the
transmission range may be less, e.g with cable thinner
4800 bps
1100 m
than than 24AWG.
9600 bps
700m
19200 bps
4oom
Some products may not be available in your country, please contact our distributor for more details
4.INSTALLATION
AU-KB3N
3-Axis keyboard
controller
Telemetric control
camera setup
RS 485
Monitor
BNC video input
DVR
6
Advertisement
