Product Features The door can be opened with a card as well as a key tag. The door can be opened with a transit card or a credit card with the transit card function as well as a key pad contained in the product. Up to 20 cards may be registered.
Table of Contents Product Features Safety Cautions Notes before Operation Model-by-Model Functions ............7 Product Components..............8 Outdoor Unit Parts ..............10 Indoor Unit Parts ...............12 Mortise ..................13 Replacing the Batteries ..............14 Using the Emergency Battery ............15 Using the Emergency Key (Except for SHS-5120VMX model) ...16 Basic Functions Initialization (Password, Card, Key Tag and Remote Controller) ..
Safety Cautions This section contains important information to ensure the user's safety and prevent potential damage to property. Please read this section carefully and use the product accordingly. Warning, Caution and Note Explained: Warning Information given under this heading is information the user must be aware of to prevent physical harm.
Cautions during Installation The user shall not install or repair Do not install the product in the the product without authorization. place where the gap between the The manufacturer does not assume door and the frame is 5mm or responsibility for damage to the more.
Cautions during Operation Be careful not to trap fingers while Handle the remote controller with opening or closing the care. number cover. The remote controller can be damaged There is a risk of by a strong impact, fingers being such as being trapped in the gap.
Notes before Operation Model-by-Model Functions The following table shows the functions available for each model of the SHS-5120 series. Interface to Interface to Emergency Pass Key Tag Remote Wireless Wireless Model word (Card) Controller HA Devices HA Devices (One-way) (Two-way) SHS- ○...
Product Components Key Tag Outdoor Unit Indoor Unit Mortise Strike Box Strike ‘AA’ Batteries (LR6) User Guide Emergency Key (Except for SHS-5120VMX model)
Handle Shaft Handle Shaft Spring Support Panel and Indoor Unit Support Panel and Outdoor Unit Fastening Bolts Fastening Bolts FH+M4×8 (4EA) OH+M5×25/TH+M5×20 (2EA) Indoor Fastening Bolts Strike Fastening Bolts PW+#8×16 (4EA) FH+U10-24×10 (4EA) Options Remote Controller Cradle 'AAA' Batteries (LR03) Remote Controller The product components used may vary depending on the installation environment.
Outdoor Unit Parts Number Pad Lighted Number Pad Number Pad Unlighted [Enter Number] Button and Running LED Card Reader Outdoor Unit Handle Emergency Keyhole (Except for SHS- 5120VMX model) External Power Contact...
Name Description Number Pad Enter numbers when registering, changing, or deleting the password. The door can be opened by entering the registered password onto the number pad. [Enter Number] The number pad is lighted so that numbers can be entered well. Button and Running LED Card Reader...
Name Description Battery Cover The Battery Cover protects the batteries and the registration button. Registration Button The Registration Button is used to register or delete a card or key tag. Automatic/Manual This switch is used to switch between automatic locking and manual Locking Toggle locking.
Replacing the Batteries 1. Battery Replacement Alarm Generation If an alarm that sounds like a ‘Toot~’ sounds Warning when opening the door using the password or tune~ card (key tag), it is time to replace the batteries. Battery Life Although actual battery life differs depending on the manufacturer, date of production and operation environment, eight 1.5V AA alkaline batteries can last for one year, based on an average of 10 uses per day.
Using the Emergency Battery 1. When Lock Fails to Operate Due to Discharged AA Batteries If the batteries are not replaced after their replacement time comes, they will be completely discharged and the door lock will not operate. Recognition of Card or Key Tag Password Entry The door is not opened.
Using the Emergency Key (Except for SHS-5120VMX model) The emergency key is used when the door lock does not operate due to discharged batteries or a circuit problem. An emergency keyhole is located at the bottom of the outdoor unit. Insert the key into the keyhole and rotate it to the left and to the right to release the door lock.
Basic Functions This section describes the ways to initialize the information registered in the door lock, to register the password and card data, and to open or close the door. Initialization (Password, Card, Key Tag and Remote Controller) All registered data (password, card and key tag) are deleted. After initialization, the password is set to '12345', and the registered card and key tag data are erased.
Password Registration and Change The password can be 5~12 digits number. Only one password can be registered. Please register a new password after initialization. Always hold the door open while registering or changing Open the password. 1. Pressing the [Password] button (from inside) Open the battery cover of the indoor unit and Toot briefly press the [Password] button.
3. Entering a New Password (from outside) Toot, toot Enter the new password (5 to 12 digits) and press the [ ] button. - To prevent burglary, it is recommended to use a password of 6 digits or longer. (Only numbers between 0 and 9 can be used.) 4.
Card and Key Tag Registration Up to 20 cards, including the key tag, can be registered. (Only ISO14443 A Type is available.) Registering a card or key tag is available while the door is open. 1. Pressing the [Register] Button (from inside) Toot Open the battery cover of the indoor unit and briefly press the [Register] button.
4. Confirming Card or Key Tag Registration (from outside) Place the registered card or key tag to the card reader on the outdoor unit. - Please refer to "Opening the Door from Outside with a Card or Key Tag" on page 28. €...
Deleting the Card or Key Tag Registered cards cannot be individually deleted. All card information is deleted when the card delete function is selected. Previously registered cards cannot be used to open the locked door after they are deleted. 1. Pressing the [Register] Button (from inside) Toot Toot, toot Open the battery cover of the indoor unit and press and hold the [Register] button for 5...
Remote Controller Registration Up to two remote controllers can be registered. 1. Pressing the [Remote] Button (from inside) Toot Open the battery cover of the indoor unit and briefly press the [Remote] button. 2. Entering the Password (from outside) Too~~~t, toot, toot Enter the password when the number pad is lighted, and press the [ ] button.
4. Confirming the Remote Controller Registration (from outside) In Automatic Locking Mode - Briefly press the [OPEN] button on the remote controller. In Manual Locking Mode - When the [OPEN] button on the remote controller is pressed, the door will be locked, or the lock will be released.
Deleting the Remote Controller Registered remote controllers cannot be individually deleted. All remote controller information is deleted when the remote controller delete function is selected. A previously registered remote controller cannot be used to open the locked door after it has been deleted.
Wireless HA Device Registration and Deletion Wireless HA products from Scommtech (7000 and 8000 series or higher) are compatible with the door lock. Please call your local dealer to register or delete the registered wireless HA device. Refer to the operating manual of the wireless HA device to open the door using the device.
Opening the Door from Outside with a Password 1. Pressing [Enter Number] button Press the [Enter Number] button, and the number pad is lighted. 2. Entering the Password Successful: " Toot, toot, toot" Failed: “Toot~” Enter the password, and press the [ ] button or the [Enter Number] button.
Opening the Door from Outside with a Card or Key Tag The door can be opened from outside using a card or key tag. Place the registered card or key tag on the card reader. Applying the Card or Key Tag Successful: "...
Opening the Door from Inside Pressing the [Open/Close] Button Too~~~t Press the [Open/Close] button on the indoor unit. Pulling down the Door Lock Handle Too~~~t Rotate the door lock handle of the indoor unit downward. Rotating the Manual Open/Close Lever Right and Left Rotate the Manual Open/Close lever on the indoor unit to the right or left to lock or unlock the door.
Pressing the [OPEN] Button of the Remote Controller Press the [OPEN] button of the remote controller. - The door is locked or unlocked each time the [OPEN] button of the remote controller is pressed in the manual locking mode. Pressing the [Open Door] Button of a Wireless HA Device The door is unlocked when the [Open Door] button of the wireless HA device is pressed.
Closing the Door from Outside Pressing the [Enter Number] Button Press the [Enter Number] button on the outdoor unit when the door has been opened from inside in manual locking mode. Closing the Door from Inside In Automatic Locking In Manual Locking Mode Mode The door is automatically locked 2 seconds The door is locked when the [Open/Close]...
Additional Functions Automatic/Manual Locking Setting The automatic locking mode allows for automatic locking of the door when it is closed. Automatic Locking Setting Manual Locking Setting Set the [Automatic/Manual Locking] toggle Set the [Automatic/Manual Locking] toggle switch of the indoor unit to the 'Automatic' switch of the indoor unit to the 'Manual' position.
Sound Setting and Releasing The sound that is generated when the number buttons are pressed, when the door is locked or when the locked door is unlocked, can be set according to the user's preference. Sound Function Setting The product is set to generate all sounds at the factory. (Set in 2 steps) Too~~~t Toot Sound Function...
Alarm Sound/Emergency Sound Alarm Sound (Prank Prevention Function) This function generates an alarm sound and deactivates door lock operation when it is improperly handled from outside. Card or Password Error Number Pad Operation Error “Toot~ Too~t” “Toot~ Too~t” (for 10 seconds) (for 10 seconds) This alarm will sound if an attempt is made to This alarm will sound if the [Enter Number]...
Setting the Security Function This function prevents intrusion from outside while the residents are out. Once set, it generates an alarm sound when the door lock is operated from inside. Too~~t, Too~~t Too~~~t Press the [Enter Number] Press and hold the [#] Enter the password and button on the outdoor button on the outdoor unit...
Intrusion Detection Function This function generates the alarm sound when an attempt is made to forcefully open the door from the inside or the outside. (This is a basic function of the lock, and cannot be separately set or released.) “Toot~, toot~, toot~”...
Double Locking The double locking function prevents opening of a locked door from outside. [Inside] Too~~~t Press the [Open/Close] button for 2 seconds or longer from the inside while the door is locked. [Inside] [Outside] Too~~t, Too~~t, too~~t too~~t The double locking sound is generated The double locking sound is generated and when the [Open/Close] button is the door cannot be opened when the [Enter...
Troubleshooting Please refer to the following if the door lock does not operate properly. If the problem can still not be solved, contact the nearest service center. Power Source Problem Solution Remark - Check to ensure the batteries are in good condition, with the poles (+/-) correctly placed.
Password / Card or Key Tag Problem Solution Remark opened with the - The door cannot be opened from the outside using the password, card or key password, card or key tag if the double locking function tag. has been activated. If the double locking function is P.
Operating Method Summary ※Make sure if a door is open to initialize, register, change or delete registered data Setting or Releasing Function Default (Press the buttons in the given order.) Initialization (Password, card, Press and hold the [Password] button for 5 seconds Enter key tag and remote the current password or '4560852580'...
Setting or Releasing Function Default (Press the buttons in the given order.) Card or Key Tag: Apply the card or key tag to the reader. Password: Press the [Enter Number] button. Enter the Opening the Door password. button from Outside Emergency Key: Insert the emergency key in the emergency keyhole and rotate it to the right and left.
Product Specifications Item Specifications Voltage 8 AA Alkaline 1.5 Batteries (LR6) (6V) Emergency Power 9V Battery (6LF22) (Separately purchased) Source Operation Method Electronic Control Method (Password entry or card or key tag reading) Weight 2.6Kg (including both indoor and outdoor units) Product Dimensions Outdoor Unit 82 mm(W)×299mm(H)×65.5 mm(D)