Disable-Port; Enable-Port - Teldat -Dm 776-I Manual

Teldat SA
Example:
ethernet0/0 PSE+?

disable-port

enable-port

list-status
mode-port
restart-pse
exit
ethernet0/0 PSE+
2.3.2 DISABLE-PORT
Disconnects (i.e. stops providing power to a previously connected port).
Syntax:
ethernet0/0 PSE+disable-port <port number>
Example:
ethernet0/0 PSE+list-status
POE cards: - POE card 1 (Ports 5-8)
Available PSE output power = 120000 mW
Minimum PSE output power
POE output power per port
Ports Status
Port 5: Detect Open Circuit
Port 6: Detect Good, Class2, requested 7000 mW, applied 7000 mW
Port 7: Detect Open Circuit
Port 8: Detect Open Circuit
ethernet0/0 PSE+disable-port 6
Port 6 disabled
ethernet0/0 PSE+list-status
POE cards: - POE card 1 (Ports 5-8)
Available PSE output power = 120000 mW
Minimum PSE output power
POE output power per port
Ports Status
Port 5: Detect Open Circuit
Port 6: [Adm. disabled] Disabled
Port 7: Detect Open Circuit
Port 8: Detect Open Circuit
ethernet0/0 PSE+
2.3.3 ENABLE-PORT
Reconnects (i.e. supplies power to a previously disconnected port).
Syntax:
ethernet0/0 PSE+enable-port <port number>
Example:
ethernet0/0 PSE+list-status
POE cards: - POE card 1 (Ports 5-8)
Available PSE output power = 120000 mW
Minimum PSE output power
POE output power per port
Ports Status
Port 5: Detect Open Circuit
Port 6: [Adm. disabled] Disabled
Port 7: Detect Open Circuit
Port 8: Detect Open Circuit
ethernet0/0 PSE+enable-port 6
Port 6 enabled
ethernet0/0 PSE+list-status
POE cards: - POE card 1 (Ports 5-8)
PoE Power over Ethernet
Disconnect a connected port
Reconnect a disabled port
Display ports status
Set port operating mode
Restart PSE control
= 7000 mW
= As requested
= 0 mW
= As requested
= 0 mW
= As requested
2 Monitoring
9