Epson BrightLink 685Wi Setup Manual page 37

Note: For the most accurate calibration, be sure to touch the center of the circle with the tip of your
finger.
Note: Make sure you are not blocking the signal between your finger and the interactive receiver
(next to the projection window on the projector).
8. Touch the center of the next circle with your finger and continue until all of the circles disappear.
When you get to the bottom of a column, the next circle appears at the top of a new column.
Note: If you make a mistake, press the Esc button on the remote control to go back to the previous
circle. To restart the calibration process, press and hold the Esc button for 2 seconds.
9. If the cursor location and your finger position do not match, repeat these steps to calibrate again.
37