Lenovo Thinkvision E24-10 User Manual page 9

1-4 E24-10 Flat Panel Monitor User's Guide
3. Connect one end of the DP cable to the DP connector on the back of the computer, and the
other end to the DP connector on the monitor. Lenovo recommends that customers who require
to use the Display Port input on their monitor purchase the "Lenovo Display Port to Display
Port cable 0A36537".
www.lenovo.com/support/monitoraccessories
4. Connect the analog signal cable to the D-SUB connector of the monitor and the other end on
the back of the computer.
5.
Plug the monitor power cord and the computer cord into grounded electrical outlets.
Note: A certified power supply cord has to be used with this equipment. The relevant national
installation and/or equipment regulations shall be considered. A certified power supply
cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227
(designation H05VV-F 3G 0.75mm² or H05VVH2-F2 3G 0.75mm²) shall be used.
Alternative a flexible cord be of synthetic rubber according to IEC 60245 (designation
H05RR-F 3G 0.75mm²) shall be used.