Bagging The Clippings - Toro 20381 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it
and lock the side-discharge door; refer to
Side-Discharge Chute (page
Installing the Grass Bag
1. Route the starter rope around the lower-rope guide
(Figure 23).
1. Lower-rope guide
Note: The lower-rope guide releases the starter rope
when you pull the recoil-start handle.
2. Raise and hold up the rear door
1. Rear door
3. Pull out the rear plug
4. Hang the upper front edge of the bag from the
grass-bag pins on the notches of the handle brackets
(Figure 25).
Removing the
15).
Figure 23
(Figure 24).
Figure 24
2. Rear plug
(Figure 24).
1. Rear door
2. Notches—handle brackets
(2)
5. Lower the rear door.
Removing the Grass Bag
1. Route the starter rope around the lower-rope guide
(Figure 26).
g007650
1. Lower-rope guide
Note: The lower-rope guide releases the starter rope
when you pull the recoil-start handle.
g007285
2. Raise and hold up the rear door.
3. Lift the grass bag up by the handle off the notches of
the handle brackets.
4. Install the rear plug (Figure 23).
13
Figure 25
3. Grass-bag pin (2)
Figure 26
g007287
g192196