Lubricating The Wheel Gears; Replacing The Blade - Toro 20381 Operator's Manual

1. Cover
2. Fuse holder
3. Spare fuse
Note: Your machine comes with a spare fuse in the
battery compartment.
4. Install the cover over the battery compartment
43).

Lubricating the Wheel Gears

Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear wheels with
a clean rag (Figure
1. Grease fitting
2. Install a grease gun onto each fitting and gently apply 2
or 3 pumps of #2 multi-purpose, lithium-base grease.
Figure 43
4. Battery compartment
5. Fuse
44).
Figure 44

Replacing the Blade

Service Interval: Yearly
Important: You will need a torque wrench to install the
blade properly . If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of fuel. If the blade
is damaged or cracked, replace it immediately. If the blade
edge is dull or nicked, have it sharpened and balanced, or
replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
g189463
1. Refer to
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
45).
(Figure
4. Remove the blade, saving all mounting hardware
(Figure
5. Install the new blade and all mounting hardware
(Figure
g003234
21
Preparing for Maintenance (page
Figure 45
45).
46).
18).
(Figure
g005454