Calling; Dialling With Number Keys; If The Number Is Busy; End Call - Siemens MC60 User Manual

of MC60 Maguro, kurz, am, A31008-H5760-A40-1-4A19 (08.08.2003, 12:31)
right page (17)

Calling

Dialling with number keys

The phone must be switched on
(standby mode).
Enter number (always
with area
code/international
dialling code).
§Clear§
the last digit, a long press
clears the entire phone
number.
Press the Call key. The
displayed phone number
is dialled.

End call

Press the End key briefly.
Press this key even if the
person on the other end
of the line has hung up
first.

Set volume

Use the top of the control
key to start adjusting the
volume. Then press
top/bottom to adjust the
volume as required (only
possible during a
conversation).
If a Car Kit is used, its volume setting
will not affect the usual setting on
the phone.
A short press clears
Redial
To redial numbers that were dialled
previously:
Press the Call key once.
Pick out the required
phone number from the
list, then to dial ...
Press ...

If the number is busy

Auto. redial
Press. The phone number
§Auto dial§
is automatically dialled
ten times at increasing
time intervals.
Or
Call back
Press. Your phone rings
§Call back§
when the busy number is
free.
Reminder
§Prompt§ Press. A beep reminds you
to redial the displayed
phone number after
15 minutes.
International dialling codes
Hold down until a "+"-is displayed.
§+List§ Press and select country.
Calling 17
b