Genie Z45/25J Operator's Manual page 23

Second Edition • Fifth Printing
Test the Drive Enable System
50 Press down the foot switch and lower the boom
to the stowed position.
51 Rotate the turntable until the primary boom
moves past one of the non-steer wheels.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
52 Move the drive control handle off center.
Result: The drive function should not operate.
53 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive
chassis to identify the
direction of travel.
Part No. 114047
Blue
Yellow
Self-Propelled Servicing Platform
Test Auxiliary Controls
54 Shut the engine off.
55 Pull out the red Emergency Stop button to
the on position.
56 Press down the foot switch.
57 Simultaneously hold auxiliary power switch on
and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
Test Aircraft Protection Package
58 Extend the primary boom 2 ft / 60 cm.
59 Move the gray bumper at the bottom of the
platform 2 inches / 5 cm in any direction.
60 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should not
operate.
61 Move the function override switch to either side.
62 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should
operate.
Operator's Manual
FUNCTION TESTS
21