yacht beam YB 1MM+ Product Support Manual page 7

WARNING: The Yacht Beam 1MM+ has a unique wiring scheme.
Special attention must be paid to the following chart.
Wiring from Interface box
Red and White Up and Down
Black and Brown Left and Right
If the Up and Down direction is opposite, reverse the Red and White wires.
If the Left/Right direction is opposite, reverse the Black and Brown wires.
Wiring from Interface box
Pressing the Thumb Joystick straight down (toward Dash) will turn the system on.
Pressing the Thumb Joystick Left, Right, Up or Down will move the spot light in that Direction.
Pressing the Thumb Joystick stright down (toward the Dash) again will turn the system off.
CAUTION: HID light systems, when first turned on, have a high inrush
current requirement of 25 amps. If you activate the light and the lamps
flicker on and off repeatedly, check the voltage being supplied.
This condition can be experienced with voltage input of less than 11.5V.
WARNING: Failure to follow this arrangement may
damage components.
DIRECTION CONTROL WIRING
Red
White
Black
Brown
White
Black
Knob on bottom adjusts speed of movement.
SYSTEM OPERATION
16/4
BULB WIRING
12/2
Spotlight harness
Red
White
Black
Brown
Spotlight harness
White
Black
7