Table of Contents
Advertisement
SECTION 2 - SEARCHLIGHT MOUNTING
Make sure the area is clean and dry. The searchlight can be mounted where desired, using appropriate length 5/16"
diameter stainless steel fasteners. One set is provided in the mounting kit and four (4) nylon shoulder washers. The
nylon washers prevent a galvanic reaction between the mounting hardware and the base of the searchlight. Be sure
these washers have been inserted in the base mounting holes and that the mounting base gasket is securely in place
before bolting down. Apply silicone grease to the bottom of the gasket to help in waterproofing the unit. When mounting,
be sure the searchlight is able to rotate 360° without hitting any obstructions. For the drilling hole pattern, refer to the
searchlight Mounting Template.
CAUTION: Do not mount the searchlight upside down.
Moisture cannot drain from the inverted light head assembly.
Joystick
Figure 2 - Master Controller unit (mounted upright)
Joystick connection configuration
Ya
Yacht Beam 1MM+
4
Advertisement
Table of Contents
