ELA Aviacion ELA 07 Pilot Operator's Handbook page 41

ELA 07-07S PILOT OPERATOR´S HANDBOOK
4.6 TAKE-OFF
Once the pre-rotation procedure is finished gently move the control stick
fully back to its stop, release wheel brakes and increase the engine power
progressively.
Make sure the control stick is fully back before start the take-off run.
A take-off run with flat rotor may have fatal consequences.
Check the engine speed is 5400 rpm or more. If not, abort the take-
Use the rudder pedals to keep the alignment of the runway (right pedal).
Once the nose wheel lifts, gently move the control stick forward to keep it
at approx. 10 cm (4 in) off the ground while the gyroplane accelerates.
When the gyroplane takes-off perform a level flight until reaching 100 kph
(60 mph/55 kts) and then raise the nose to keep this speed.
Use the pitch trim to adjust the speed of the gyroplane:
Trim back = Nose up = reduce speed.
Trim forward = Nose down = increase speed.
Remember: adjust the speed with the control stick, climb and
Version: V07-05
WARNING
CAUTION
off.
Note
descend with engine power.
41
Last modification: September 2017.