Installation; Drainage Connection - Asko DFI643 Operating Instructions Manual

Hide thumbs Also See for DFI643:
Table of Contents

Advertisement

Installation

It is important that you read through and follow the instructions and
directions below. Conduct installation and connection in accordance
with the separate installation instructions.
Safety instructions
Connections to electricity, water and drainage must be performed
by a qualified professional.
Always follow applicable regulations for water, drainage and elec-
tricity.
Take care during installation! Wear protective gloves! There must
always be two people!
Before screwing the dishwasher into place, test the dishwasher by
running the Rinse and hold program. Check that the dishwasher
fills with water and drains. Check also that none of the connections
leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the socket turned off
while the work is carried out!
Setup
The dimensions and connection information are included in the
separate installation instructions. Check that all dimensions and
connections are correct before commencing the installation. Note
that the height of the exterior panel can be adjusted to match other
fittings.
Make sure the area on which the dishwasher is to be installed is
firm. Adjust the adjustable feet so that the dishwasher is level.
Tighten the lock nuts.
Stronger door springs are available for purchase for dishwashers
with a fitted wooden door. Springs are available for various weights
and sizes of wooden door. Door springs can be purchased from
the retailer who sold you the dishwasher.
20
596
573
*Remove locking nuts for an installed height of 820-821 mm.
**Door length.
559
50

Drainage connection

See the separate installation instructions for necessary information.
The drainage hose may be extended by a maximum of 2.5 m (the total
length of the drainage hose must not exceed 4.5 m). Any joins and
connecting pipes must have an internal diameter of at least 14 mm.
However, the drainage hose should ideally be replaced with a new
hose without joins.
No part of the drainage hose may be more than 950 mm above the
bottom of the dishwasher. The hose must not be routed directly to a
floor drain or the like. In such cases, the hose can act as a siphon and
empty the dishwasher.
The hose must always discharge at least 350 mm above the bottom
of the machine.
Ensure that the drainage hose has no kinks.
NOTE!
When the drainage hose is routed to a connection nipple on the sink
unit's water trap (see Illustration 1), please note that the hose must
be attached at the same height as the underside of the sink unit.
Otherwise dishwater from the sink may flow back into the dishwasher.
For other connection alternatives, see Illustrations 2 and 3.
1
2
[mm]
1198
30-94
Nominal dimensions. Actual measurements may vary.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents