Store - TC Electronic Finalizer 96K User Manual

STORE

Storing a User preset and handling preset names
(You can store your preset in the RAM bank only, and the Finalizer therefore automatically selects this bank)
Note that you can always move the cursor using the PARAMETER keys)
What is stored where?
Global parameters (or system parameters) are not affected by
preset recalls. The parameters include:
- Input and Output blocks on the Main page (except Lo-cut):
Formats, I/O levels, Insert Enable and Dither.
- Parameters in the Utility page.
- Parameters in the Tools Digital out page.
To reset the Global parameters, follow the guidelines on page 42
of this manual.
Preset parameters may change with every preset and when the
Wizard is invoked. They are modified in most Blocks of the
Main page. Exceptions are the In and Out Blocks. (However, Lo-
cut in the In block is also part of a preset).
(Select letters with the ADJUST wheel and confirm each letter with OK.
Note: Asking for an External Insert is part of a preset. Enabling
a specific External Insert is part of the Global parameters.
When an Analog Insert is specified, the I/O interface levels are
stored with the preset.
Using a Memory card:
Insert the card. The Finalizer will now autodetect your card and
the Store and Recall facilities will be attached to the memory
card. The Finalizer will now use the memory card as its RAM
bank. When you remove your memory card, the Finalizer will
switch back to the internal RAM bank.
If the format of the memory card is not correct, the Finalizer will
detect this immediately. The card will automatically be formatted
the first time you save or dump information to the card.
Note: This will destroy all exsisting information on the card.
S-RAM Type 1 PCMCIA cards, with a minimum of 64 KB and a
maximum of 2 MB memory.
13