Installing The Home Connect Software Update; Information On Data Protection - Bosch B0**IB***** Operating Instructions Manual

Verify signal strength
You should verify the signal strength if no connection
can be established.
1. Press the Home Connect button 6.
The temperature display refrigerator compartment 8
indicates Cn.
2. Press the refrigerator compartment temperature
selection button 7 until the temperature display
refrigerator compartment 8 indicates SI. The
temperature display freezer compartment 4 indicates
a value between 0 (no reception) and 3 (full
reception).
The signal strength should be at least 2. If the signal
strength is too weak, the connection may be
interrupted.
Place the router and refrigerator closer together.
■
Ensure that the connection do not interfere with by
■
screening walls.
Alternatively, install a repeater to make the signal
■
stronger.
Resetting Home Connect settings
If there is a problem when trying to establish a
connection or if you want to register the appliance in a
different home network (WLAN), the Home Connect
settings can be reset:
1. Press the Home Connect button 6.
The temperature display refrigerator compartment 8
indicates Cn.
2. Press the refrigerator compartment temperature
selection button 7 until the temperature display
refrigerator compartment 8 indicates rE and the
temperature display freezer compartment 4 indicates
OF.
3. Press the freezer compartment temperature selection
button 3.
The temperature display freezer compartment 4
displays an animation for 15 seconds.
Then the temperature display freezer compartment 4
indicates OF.
The Home Connect settings have been reset.
Installing the Home Connect software
update
The refrigerator checks for updates to the Home
Connect software at regular intervals.
When an update is available, the temperature display
refrigerator compartment 8 indicates UP.
Press any button to reset the display to the set
temperature.
Installing the update:
1. Press the Home Connect button 6.
The temperature display refrigerator compartment 8
indicates Cn.
2. Press the refrigerator compartment temperature
selection button 7 until the temperature display
refrigerator compartment 8 indicates UP and the
temperature display freezer compartment 4 indicates
OF.
3. Press the freezer compartment temperature selection
button 3.
The temperature display freezer compartment 4
displays an animation.
The update is installed.
During the installation, all buttons are locked.
If the installation was successful, the temperature
■
display freezer compartment 4 indicates On.
If installation was not successful, the temperature
■
display freezer compartment 4 indicates Er. Start
the update again at a later time. If the installation
has still not been successfully completed after
several attempts, inform customer Service.

Information on data protection

When your Home Connect refrigerator is connected for
the first time to a WLAN network that is connected to the
Internet, your appliance transmits the following
categories of data to the Home Connect server (initial
registration):
Unique appliance identification (consisting of
■
appliance codes as well as the MAC address of the
installed Wi-Fi communication module).
Security certificate of the Wi-Fi communication module
■
(to ensure a secure IT connection).
The current software and hardware version of your
■
domestic appliance.
Status of any previous resetting to factory settings.
■
This initial registration prepares the Home Connect
functions for use and is required only when you want to
use Home Connect for the first time.
Note:
Note that the Home Connect functions can be used only
in conjunction with the Home Connect app. Information
on data protection can be accessed in the Home
Connect app.
en-us
13