Horizontal Right With Vertical Vent - Rheem 96P series Installation Instructions Manual

HORIZONTAL RIGHT / VE
AIRFL OW
PARTS NEEDED:
FROM PARTS BAG
(PROVIDED WITH UNIT)
FROM CONVERSION KIT RXGY-CK RXGY-CK
1/2" DRAIN
1/2" DRAIN
HOSE E
TOOLS/MATERIALS NEEDED:
DRILL PLIERS
1/8" DRILL BIT FLAT HEAD SCREWDRIVER
NOTE: THESE CONVERSION INSTRUCTIONS ARE INTENTIONALLY GENERIC, SOME P
NOTE: STEPS 1- 5 SHOWN WITH FURNACE IN "AS SHIPPED CONDITION"
1
1a - REMOVE FLUE TRANSITION, TRANSITION COUPLING, AND ELBOW.
(NOTE: REMOVE INDUCER COUPLING W/ ELBOW FOR EASIER
REMOVAL).
1b - REMOVE CONDENSATE TRAP AND HOSES.
(NOTE: TO REMOVE TRAP REMOVE (2) SCREWS AND PULL
STRAIGHT OUT).
1a
1b
INTAKE
INTAKE AIR
COUPLING
DIFFUSER
AND NUT
CONDENSATE
TRAP GASKET
.559 DRAIN
PLUG
HOSE F
5/16 HEX HEAD DRIVER
1/4" HEX HEAD DRIVER
FLUE TRANSITION (DISCARD)
TRANSITION
COUPLING
(RETAIN)
ELBOW (DISCARD)
IDB COUPLING
(RETAIN)
VENT HOSE
(DISCARD) (DISCARD)
HOSE "D"
(DISCARD)
ERTICAL VENT
PARTS NEEDE ED FOR THIS CONVERSION REQUIRE ITEMS
!
FROM THE PA RTS BAG AND CONVERSION KIT RXGY-CK
YOU MUST HA AVE THE PARTS OUTLINED BELOW BEFORE
PROCEEDING.
(X3)
#8 X 1/2"
1/4" " BLACK
SCREW VEN NT TUBE
TUBING CU UTTER
PARTS MAY BE DIFFERENT IN YOUR FURNACE
2
2a - RELO OCATE 1/2" VINYL CAP (YELLOW) ON THE INDUCER COUPLING.
2b - REMO OVE 3-3/8" FLUSH MOUNT PLUG FROM JACKET SIDE-DISCARD.
2c - RELO CATE 2-3/8" FLUSH MOUNT PLUG FROM JACKET TO TOP PLATE.
2d - INSTA ALL 2-5/8" FLUSH MOUNT PLUG IN TOP PLATE.
2d INSTALL
2-5/8"
DISC CARD
2b b
NOTE:
IF THE IDB COUPLING IS REMOVED, IT MUST BE REPLACED IN THE
PROPER ORIENTATION. AN ARROW IS PRESENT ON THE COUPLING
TO INDICATE THE DIRECTION OF EXHAUST FLOW. MAKE SURE THE
ARROW POINTS IN THE CORRECT DIRECTION.
2-5/8"
2-5/8" FLUSH
2" PIPE GROMMET
MOUNT PLUG
( 3.375)
MOVE
2a
RE E-LOCATE
2c
ST-A1194-33-02
31