Need Help - Neurio Installation Manual

Step 5
OFF
O FF
1 ) Remove the top bracket of the CT
by inserting your finger through
the loop and pulling towards you.
Be
CAUTION:
sure to take care
to not touch the
exposed main line connections
to the main breaker.
2 ) Loop the CTs around each of the
main power lines and attach the
bracket to the CT again.
NOTE :
Make sure the label on the CT is
facing the utility (where the power comes
from) and not the breaker panel.
GlobalTestSupply
Find Quality Products Online at: www.
3 ) Insert the connector from the CT that's on the
same phase as the black Neurio voltage wire into
port labeled (1). Then insert the connector from
the second CT into the port labeled (2).
Having troubles trying to figure out which phase a CT is on?

NEED HELP?

Visit support.neur.io for tips.
.com sales@GlobalTestSupply.com
2
1