Safety 1st WANDERER X Manual

Safety 1st WANDERER X Manual

3 wheel stroller suitable for newborn to 17kg

Advertisement

0m+
17KG
Illustration and designs may vary.

Advertisement

Table of Contents
loading

Summary of Contents for Safety 1st WANDERER X

  • Page 1 17KG Illustration and designs may vary.
  • Page 2: Table Of Contents

    Install and Use Bassinette ..............20 - 22 Install and Use Infant Carrier ..............23 - 24 CARE AND MAINTENANCE Care and Maintenance ................. 25 Notes ..................... 26 - 27 CONTACTS Customer Service ..................28 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 3: Warnings

    • Do not use the stroller near an open fire, barbecue or exposed flame. • This product is not intended for commercial use. • Do not run or jog with this stroller. • This product is tested to AS/NZ 2088:2013 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 4 The weight of the child using the Bassinette should not be more than 9kg. • Please refer to instruction manuals of the Maxi-Cosi Infant Carrier & Wanderer Bassinette for full weight and height specifications. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 5: Components List

    Folding Lock (both sides) Bumper Bar Storage Latch Harness Pads Shopping Basket Safety Harness Brake Lever (both sides) Adjustable Legrest Rear Wheels Assembly Swivel Wheel Lock Never Flat Tyres (x3) Front Wheel 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 6: Opening Stroller

    This vehicle is designed for use on flat or gently sloping surfaces and may be unstable on higher sloping and uneven surfaces. You should always be aware of the possibility of the stroller tipping on uneven or higher sloping surfaces. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 7: Wheel Assembly

    Pull rear wheel from the hub, as per Figure 2c. • Repeat on other side. Push Push Note: Never Flat tyres do not require air. The tyres are maintenance free. Push 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 8 Listen for ‘CLICK’ to confirm locking position. TO REMOVE FRONT WHEEL • Slide the plastic button while pulling the front wheel off the front hub, as per Figure 3b . Slide Click! Push Pull 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 9: Fitting Seat

    Then press button (C) and lift out the seat, as per Figure 4e. Push Click! Press (B) Lift Slide (A) Press (C) Opposite side WARNING Do not use this seat with any other models of stroller. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 10: Bumper Bar

    TO REMOVE BUMPER BAR • Remove bumper bar from frame. • Press the plastic button and slide bumper bar upwards, as per Figure 5b & Figure 5c. Slide Push Slide 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 11: Canopy

    TO REMOVE THE CANOPY • Close the zip. • Push canopy backwards. • To remove canopy, pull the canopy ends from the mounting brackets, as per Figure 6b. Push Pull Open 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 12: Front Swivel Wheel

    TO LOCK: Push the swivel lock downwards, as per Figure 7a. • TO UNLOCK: Lift the swivel lock upwards, as per Figure 7b. Press Lift to down unlock to lock 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 13: Operating Brakes

    TO RELEASE THE BRAKES: Lift the red brake pedal until it is fully disengaged, as per Figure 8c. • Both indicators should be green, as per Figure 8d. Lift WARNING Apply all the brakes whenever you park the stroller. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 14: Adjusting Handle / Backrest / Legrest

    Lift the lever, as per Figure 10a and set the backrest to the desired position, as per Figure 10b. Note: The backrest can be adjusted to 3 different positions. Lift 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 15 ADJUSTING THE LEGREST • Press both adjustment buttons simultaneously and lift to the desired position, as per Figure 11a & 11b. Note: Listen for click. Press Press Adjust Click! 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 16: Securing Your Child

    4. The harness should resemble this image. 5. The buckle is released by squeezing the top and bottom prongs together until harness disengages. (Figure 5). SQUEEZE 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 17: Adjusting Harness Height / Tether Strap

    • Whenever a child is in the stroller and brakes are not engaged, the large loop should be around your wrist, as per Figure 14. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 18: Folding / Unfolding / Carrying Stroller

    Note: Lift handle to check that the lock has fully engaged. Pull Lift Storage Latch UNFOLDING STROLLER • Refer to page 6, Opening Stroller, and follow same steps to unfold. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 19 Carry stroller by holding frame between folding lock and storage latch, as per Figure 16. Avoid holding the stroller in other locations to avoid injury from moving parts. Folding Lock Storage Latch CARRY HERE 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 20: Bassinette And Infant Carrier Install And Use Bassinette

    Insert the bassinette into the frame, as per Figure 17a. • Listen for ‘CLICK’. • Your stroller with bassinette is now ready for use. Push Click! INCORRECT POSITION CORRECT POSITION 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 21 SECURING YOUR CHILD • The buckle is released by squeezing the buckle tongues together, as per Figure 19. • Place infant in the bassinette and reattached the buckle. Squeeze to release 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 22 Inside the hood of the bassinette are two press studs, attach these to studs located on the lower inside of the bassinette hood, as per Figure 20. Press Studs Velcro 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 23: Install And Use Infant Carrier

    Infant Carrier into the stroller with child FACING FORWARD. For harness fitting & adjustment instructions for your Infant Carrier, please consult your instructions supplied with your Infant Carrier. INFANT CARRIER ADAPTOR Click! CORRECT POSITION INCORRECT POSITION 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 24 Figure 22. • To remove the infant carrier adaptors, press the buttons on the frame and pull adaptors off. Lift by Carry Handle Push Lift INFANT CARRIER ADAPTOR Pull Press 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 25: Care And Maintenance

    Occasionally clean and lubricate wheels with a light lubricating oil. • Regularly check for loose parts and tighten when required. • Damaged or broken parts should be immediately replaced. 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 26: Notes

    Notes 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 27 Notes 017002 - 017003 - Wanderer X Stroller - 01 - 16...
  • Page 28: Contacts Customer Service

    Specifications are subject to change without notice. Copy or reproduction without permission is prohibited. © 2016 Dorel Australia Pty Ltd. All Rights Reserved. www.dorel.com.au 017002 - 017003 - Wanderer X Stroller - 01 - 16...

Table of Contents