Table of Contents
Advertisement
iv
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Water temperature in excess of 100° F (37.7° C) may be hazardous to your health.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs
when the internal temperature of the body reaches a level several degrees above
normal body temperature of 98.6° F (37° C.). Effects of hyperthermia include:
(1) Unawareness of impending danger. (2) Failure to perceive heat. (3) Failure to
recognize the need to leave the spa. (4) Physical inability to exit the spa. (5) Fetal
damage in pregnant women. (6) Unconsciousness resulting in danger of drowning.
The use of alcohol, drugs, or medication can greatly increase the risk of fatal
hyperthermia in hot tubs and spas.
A pool or spa pump must be installed by a qualified pool and spa service professional
in accordance with the current National Electrical Code and all applicable local codes
and ordinances. Improper installation may create an electrical hazard which could
result in death or serious injury to pool users, installers, or others due to electrical
shock, and may also cause damage to property.
The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia
in hot tubs and spas. This product is intended to control heaters with built-in high limit
circuits ONLY. Failure to do so may cause property damage or personal injury.
For units intended for use in other than single-family dwellings, a clearly labeled
emergency switch shall be provided as part of the installation. The switch shall be readily
accessible to the occupants and shall be installed at least five (5) feet (1.52 m) away,
adjacent to, and within sight of, the unit.
Except for listed spa-side remote controls, install a minimum of five (5) feet (1.52 m) from
the inside wall of the pool and spa.
For information about the Virginia Graeme Baker Pool and Spa Safety Act, contact the Consumer Product Safety
Commission at (301) 504-7908 or visit www.cpsc.gov.
NOTE: Always turn off all power to the pool pump before installing the cover or working on any suction outlet.
Two Speed Pump Controls Notice (Title 20 Compliance)
Please read the following important Safety Instructions - When using two-speed pumps
manufactured on or after January 1, 2008, the pump's default circulation speed MUST be set to the
LOWEST SPEED, with a high speed override capability being for a temporary period not to exceed one
normal cycle, or two hours, whichever is less.
CAUTION: IMPORTANT BATTERY INFORMATION
•
Danger of explosion if battery is incorrectly replaced.
•
ONLY USE a Pentair Water Pool and Spa ("Pentair") replacement battery. Order Battery
(P/N 522054).
•
Rechargeable Lithium-ion battery disposal: Unwanted lithium ion battery pack may be returned to
your local recycling center or the manufacturer for disposal.
•
Dispose of used batteries according to the manufacturer's instructions.
IntelliCenter Control System Wireless Control Panel Installation Guide
Advertisement
Table of Contents
