Table of Contents
Advertisement
IntelliCenter Control System Wireless Control Panel Setup
The IntelliCenter Control System Wireless Control Panel requires optional Kit P/N 522036. This
kit includes a wireless transceiver with antenna which connects to an RS-485 COM port on the
Outdoor Control Panel circuit board located in the control system Load Center. For IntelliCenter
Control System start up information, refer to the IntelliCenter™ Control System User's Guide
(P/N 522561). Note: IntelliCenter Control System settings made on the outdoor, indoor or wireless
control panel control panel are synchronized to have the same system settings on each control
panel.
Power On the Load Center
1. After all the necessary pool and spa equipment has been connected to the Load Center, replace
and secure the High Voltage Panel onto the front of the Load Center.
2. Switch on the main circuit breakers to apply power to the Load Center.
Setup the Wireless Control Panel
1. From the Home screen on the Wireless Control Panel. Tap Settings > Advanced System
Configuration > Intellicenter Wireless Remote Setup to access the IntelliCenter Wireless
Remote Setup Screen.
Air Temp 65° F
78°
85°
84°
Pool
Schedule
Usage
3. Choose the best Channel for Signal Strength: From the IntelliCenter Wireless Remote Setup
Screen you can name the wireless control panel, view the current firmware, view the current RSSI
and LQI values and choose a channel withe the best signal strength.
IntelliCenter Wireless Remote Setup
Name
FW Version
RSSI and LQI
Channel
Signal Strength
8:00 A.M.
3
3
92°
Spa
Features
Lights
Chemistry
Status
Device
0.00
-90dB, 255
12
Name: Tap the Name button, and enter a
name for the wireless remote.
FW Version: Tap the FW Version button to
view the firmware version of the wireless
remote.
RSSI and LQI: Tap this button to view:
RSSI: A higher RSSI value indicates higher
power. Received Signal Strength (Power) In-
dication (in dBm) (RSSI). See Signal Strength
connectivity description below.
LQI: The Link Quality Indicator value is from
0 to 255 from the wireless remote transceiver
(TXR). This value is best used as a relative
measurement of the link quality. (a high LQI
value indicates a better link than a low LQI
value does).
IntellliCenter Control System Wireless Control Panel Installation Guide
9
Advertisement
Table of Contents
