Table of Contents
Advertisement
Connecting the Transceiver to the IntelliCenter™ Control System Load Center
5. Strip the leads of the communication cable wires back ¼ in. Insert the wires into the connector
screw terminals (provided in the kit). Using a small flat-blade screwdriver, secure the wires with
the COM PORT terminal screws. Make sure to match the color-coding of the wires: GND = Black,
Green = -DT, Yellow = +DT, and Red = +15. Connect the screw terminal connector onto the
transceiver circuit board.
6. Reinstall the High Voltage Panel: Insert the panel's three tabs into the lower slots on the enclosure.
Secure the panel with the two (2) retaining screws. Close the front door and secure with the latch.
7. After the IntelliCenter™ Control System Load Center is powered up the Wireless Control Panel will
automatically synchronize with the system and will be ready for operation.
8. Close the Load Center front door. Fasten the spring latch.
9. SWITCH ON AC POWER to the Load Center.
IntelliCenter Control System Main Board
COM Port
(J4)
COM Port
(J5)
COMMUNICATION PORTS A & B
IntelliCenter™ Control System COM PORT:
Strip 1/4" insulation from the green and yellow wire conductors.
• Connect the Green wire to pin 2 on Connector J4 or J5.
• Connect the Yellow wire to pin 3 on Connector J4 or J5.
Note: Multiple wires may be inserted into a single terminal.
Optional: COM PORT expansion module (P/N 520818) with 3 extra
COM PORTS up to 2 modules can be installed.
IntellliCenter Control System Wireless Control Panel Installation Guide
IntellliCenter Control System Wireless Control Panel Installation Guide
i5PS IntelliCenter Control System Main Circuit Board
(with optional Expansion Board shown)
14 VDC, 2.0A Max. Combined.
Transceiver cable to
RS_485 COM port (J4 or J5)
7
(Continued)
COM Port A (J5)
and COM Port B (J4)
14 VDC, 2.0A Max.
Combined
+15 +DT -DT GND
4
3
2
1
Connect
Advertisement
Table of Contents
