Haier A3FE632C*J series User Manual page 28

10- Installation
a
c
e
g
12.
13.
14.
17.
16.
18.
28
b
Next steps (a-h) are only necessary for models with
two doors:
a Remove lower door
b This step needs two persons; one who holds the
d
c Unscrew the two grub screws (1), remove the low-
f
d refix the lower hinge with the 2 grub screws
e Screw the lower hinge to the left side of the appliance.
= 8. + 9.
f
g Lift the lower door carefully on to the lower hinge
h
h Take out the new hinge from the accessory bag
12. Take out the new lower hinge of upper door from
13. Lift the upper door carefully on to the lower hinge
14. Take out the upper hinge from the accessory
15 Put the hinge cover (delivered in the accessory
16. Plug in the connection cable and fit it into the
17. Replace front panel and fix it with the five screws.
18 Take out the cover from the accessory bag and fix
After the change of the door check that the door seals
are located properly on the housing and all screws are
tightened well.
appliance in place and one who carries out the as-
sembly steps!
Tilt the appliance slightly backwards and remove
the lower hinge with the feet (1). Change also po-
sition of the other feet (2).
er hinge, rotates through 180° (2) and
Follow steps 8 and 9.
so that the pivot fits into the hinge barrel.
Be sure the pivot fits into the hinge barrel of lo-
wer door.
and screw it to the left side of the appliance.
the accessory bag and screw it to the left side of
the appliance.
so that the pivot fits into the hinge barrel.
Be sure the pivot fits into the hinge barrel of lo-
wer door.
bag. Put the connection cable through the up-
per hinge and fix the upper hinge with the three
screws on left side of appliance.
bag) over the hinge.
opening.
it to the right side of upper door.
GB