All T Imer; Lash /C All W Aiting; Ast N Umber R Edial - GE 28031xx2 User Manual

c t
All imer
After you press the TALK/CALL BACK button on the handset, the built-in call timer shows on
the display and counts the length of time of the call in minutes and seconds.
A s
uto tAnDBY
If you place the handset in the cradle while the handset is off the hook (during a call),
the call is automatically disconnected.
r hi/low/off (s
inGer
There are two ways to set the ringer to HI/LOW/OFF. One is the traditional way as
described in the Programming Functions; Handset Setup; Ringer Volume menus. The
other one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in talk mode).
2. Press the #PAUSE/RINGER button to display 1HI 2LOW 3OFF.
3. Use the touch tone pad on the handset to select 1, 2 or 3, or use the CALLER ID-VOLUME
( 6 or 5) button to scroll to your selection. HI is the default setting.
4. Press #PAUSE/RINGER button again to save and display the new selection for a
few seconds.
f /c w
lAsh All
If you subscribe to the combined Call Waiting Caller ID service from your local
telephone company, you will receive Caller ID information (if available) on Call Waiting
calls. During a phone call, you will hear a beep to indicate another call is waiting on the
line and Caller ID information for the waiting call shows on the handset display.
• To connect to the waiting call, press the FLASH button on the handset, and your
original call is put on hold.
• To switch between the two calls, press the FLASH button.
TIP: Do not press the TALK/CALL BACK button on the handset to activate a
custom calling service, such as call waiting, or call will disconnect.
l n
Ast umBer
You may quickly rredial the last number you dialed (up to 32 digits long).
1. Press the TALK/CALL BACK button.
2. Press the REDIAL button.
-OR-
24
hortcut
AitinG
r
eDiAl
)