Basic Operation; Remote Controlling; Commands Syntax - Hamtronix Elektra 2000 Instruction Manual

ELEKTRA 2000
CONTROLLING YOU REPEATER REMOTELY
With exception of audio levels, all functions are controlled remotely with your radio DTMF keypad.
COMMAND SINTAXES
Commands are as following:
PPPPFF0#
PPPP
Where:
FF
O
#
See the command for change the sound of courtesy tone:
1234066#
Your controller will answer valid commands with two high frequency confirmation beeps (function 08
must be enabled). If the entered command is invalid, a long, low frequency tone will be heard. The
command must be entered completely in one transmission. If you release PTT switch before you
complete a command, the entered numbers will be discarded.
You can enter more than one command without having to release PTT between them. # acts like a
command separator. If entering a command and you made a mistake, just press * to clear the entered
string and start over.
Note 1: DTMF commands without a correct password will not generate an error message. They will just
be discarded.
Note 2: Some commands don't require an option or may require extra procedures. These exceptions will
be explained in details at function description.
Note 3: Default password is 1234. After get acquainted with the controller commands, change this
password.
To get a correct decoding of DTMF tones, the signal must be free of noises or jamming. If the
repeater is busy, wait until it becomes free prior to sending commands.

BASIC OPERATION

4 digits password
2 digits function
1 digit option
Enter
WARNING
7
Hamtronix