Sound Bar Preparation - Sharp HT-SB603 Operation Manual

Sound bar preparation

To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [7.9 lbs. (3.7 kg)]
from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on
the veneer plaster or whitewashed wall. The sound bar
may fall.) If unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the
sound bar may get damaged.
SHARP is not responsible for accidents resulting
from improper installation.
Driving screws
SHARP designed the sound bar so you may hang them
on the wall. Use proper screws (not supplied). See below
for size and type.
1/8" (3.2 mm)
3/16"
(5 mm)
7/8" (Min. 22 mm)
Fixing wall mount angle
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal
position as below.
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw
point marks on the pattern paper by using a
drill.
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug (not supplied) into the
hole using a hammer, until it is flush with the
wall surface.
3/8" (8-9 mm)
Wall surface
3/8" (9 mm)
44 mm
926 mm
29 mm
Pattern paper
1-1/4" (32 mm)
1-1/4" (32 mm)
4
Screw the wall mount angle to the wall as shown
in the illustration. (Total screw is 8 pieces)
Wall mount angle
Wall mount
angle
Wall surface
(screws x 4)
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
Installing the sound bar
1
Align the wall mount slot at the sound bar to the
wall mount angle.
2
Slot the sound bar into the wall mount angle.
3
Fix them securely.
Wall surface
E-7
Wall
(screws x 4)
surface
Wall surface
Wall
mount
angle