Datalogic Memor X3 User Manual page 9

1
Do not disassemble or modify (i.e. bend, crush or deform)
the battery pack. The battery pack contains safety and
protection devices, which, if damaged, may cause the
battery pack to generate heat, explode or ignite.
WARNING
In case of leakage of liquid from the battery, avoid contact
with liquid the skin or eyes. If the contact occurs,
immediately wash the affected area with water and consult
a doctor.
Do not solder directly onto the battery pack.
Do not expose the battery pack to liquids.
Avoid any knocks or excessive vibrations. If the device or
the battery is dropped, especially on a hard surface, you
should take it to the nearest Authorised Repair Centre for
inspection before continuing to use it.
Do not replace the battery pack when the device is turned
on.
Do not remove or damage the battery pack's label.
Do not use the battery pack if it is damaged in any part.
Battery pack usage by children should be supervised.
Collect and recycle waste batteries separately from the
device in compliance with European Directive 2006/66/EC,
2011/65, 2002/96/EC and subsequent modifications, with
US and China regulatory laws and regulations about the
environment.
In order to maximize operating autonomy, the Memor X3
checks its battery level at all times. If the battery is not
sufficiently charged, the Memor X3 will not turn on when
the ON/OFF Power button is pressed.
In this case, either substitute a sufficiently charged battery,
insert the Memor X3 into a powered cradle, or plug it into a
NOTE
wall charger.
To maximize battery life, turn off radios when they are not
needed.
NOTE
6
MEMOR™ X3 REGULATORY AND SAFETY