Advertisement
Installation of tool
6
3.2 Installation Cutting tool
3.2.1 Fit cutter into rotary tool, the knife and tool are as shown in following
drawings:
3.2.2 Adjust the protruding length of the knife top as required for specific cutting
media
Correct
3.2.3 (1) Loosen the screw of tool carrier.
(2) Assembly the tool with knife into the tool Carrier.
(3) When the tool is in appropriate position screw it and fix the screw.
CAUTION
Do not touch the knife top with your
finger to prevent injury .
(front view)
Knife adjusting screw
Vinyl
Base paper
Too long protruding
length of knife tip
PROCUT
CR SERIES USER'S MANUAL
(disassembly view)
Knife handle
Too short protruding
length of knife tip
Knife
Knife sheath
Advertisement
