Advertisement
PROCUT CR SERIES USER'S MANUAL
26
another automatic paper testing.
5.13 Question: why do some nicks deep, while some shallow when cutting?
Answer: as PROCUT employs upscale soft PVC materials as knife strip cushion to
protect knife. But long period using it may produce a trace therefore
roughing the stripe cushion, so some nicks become deep, while some become
shallow. To resolve it replace a stripe cushion. If is not so worse, adjust knife
as described in section 3.2.B, increase knife press (some 120 -150).
5.14 Question: why can not the plotter run when it is outputting?
Answer：(1). Check whether the plotter is properly connected with computer.
PROCUT is connected with COM1 or COM2 of computer; check whether
the set ports are conformed to those connected.
(2). Check whether the plotter is in online state, namely whether the LCD
displays"ON LINE".
(3). Check whether the encryption card of software is properly. If not please
turn off the power and reinstall it. Check driving program of the plotter is
for PROCUT series.
5.15 Question: why can not the instant-glue be taken off?
Answer:(1). Perform trial run prior output, adjust press to appropriate level.
(2). Check whether the knife is used too long, or whether the knife top is
5.16 Question: what is attentive when cutting big characters?
Answer: (1). When cutting big characters, the system can automatically How to setup
page, you can cut a big character in several pages, but it is notable that the
setting of output width shall be conformed to the width of instant-glue in
addition, when cutting big characters and output it, you should widen pages
or set seaming distance.
(2). When you use the special wide machine to cut the big characters, especially
the long big characters Before cutting input, you shall instead the paper first
look careful the paper if the paper deviates then deviate the big characters into
some pouts to input, it can make sure it won't deviate and waste paper.
5.17 Question: how do we maintain the plotter?
Answer: PROCUT series plotter all employ upscale oil bearing from Japan, no oil is needed
even it works for a long time. After operation everyday, clean the dust with soft brush.
The glue remaining in engine base can be cleaned with alcohol. If frequently operated
in dusty environment above two years, please have maintenance technicians clean the
broken. For new ones the nick is thin in the instant-glue, while for old
ones the nick is thick and impressive. To resolve it replace it with a new
knife.
Troubleshooting
Advertisement
