HANTEL HTP-800 User Manual page 42

SAR INFORMATION
THIS MODEL PHONE MEETS THE GOVERNMENT 'S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver.It is designed and manufactured
not to exceed the emission limits for exposure to radio frequency (RF)energy set by the
Federal Communications Commission of the U.S.Government.These limits are part of
comprehensive guidelines and establish permitted levels of RF energy for the general
population.The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all
persons,regardless of age and health.
The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate,or SAR.The SAR limit set by the FCC is 1.6 W/kg.*Tests
for SAR are conducted with the phone transmitting at its highest certified power level in all
tested frequency bands.Although the SAR is determined at the highest certified power
level,the actual SAR level of the phone while operating can be well below the maximum
value.This is because the phone is designed to operate at multiple power levels so as to
use only the power required to reach the network.In general,the closer you are to a
wireless base station antenna,the lower the power output. Before a phone model is
available for sale to the public, it must be tested and certified to the FCC that it does not
exceed the limit established by the government-adopted requirement for safe exposure.
The tests are performed in positions and locations (e.g., at the ear and worn on the body)
as required by the FCC for each model. The highest SAR value for this model phone when
worn on the body, as described in this user guide, is 1.13W/kg. (Body worn measurements
differ among phone models, depending upon available accessories and FCC
requirements). While there may be differences between the SAR levels of various phones
and at various positions, they all meet the government requirement for safe exposure. The
FCC has granted an Equipment Authorization for this model phone with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines.SAR information
on this model phone is on file with the FCC and can be found under the Display Grant
section of http://www.fcc.gov / oet / fccid after searching on FCC ID : ODGHTP-1900.
Additional information on Specific Absorption Rates (SAR)can be found on the Cellular
Telecommunications &Internet Association (CTIA)web-site at http://phonefacts.net.*In the
United States and Canada,the SAR limit for mobile phones used by the public is 1.6
watts/kg (W/kg)averaged over one gram of tissue.The standard incorporates a substantial
margin of safety to give additional protection for the public and to account for any ariations
in measurements.