Poulan Pro PDGT26H48A Owner's Manual page 24

SERVICE AND ADJUSTMENTS
RETAINER
SPRING
DRIVE BELT TEN-
SION HANDLE
ENGINE PULLEY
BELT KEEPER
FLAT IDLER
BELT
BELT
KEEPER
KEEPER
V-IDLER
TRANSAXLE MOTION CONTROL LEVER
NEUTRAL ADJUSTMENT (See Fig. 28)
The motion control lever has been pre set at the factory and
adjustment should not be necessary.
• Park tractor on level surface. Stop tractor by turning
ignition key to "OFF" position and engage park ing
brake.
• Loosen the adjustment bolt in front of the right rear
wheel.
• Move motion control lever to the neutral position (N).
• Tighten the adjustment bolt.
TRANSAXLE
PULLEY
BELT
KEEPER
CLUTCHING
CLUTCHING
FLAT IDLER
IDLER
FIG. 27
AD JUST MENT
BOLT
FIG. 28
TRANSMISSION REMOVAL/REPLACEMENT
Should your transmission require removal for service or
re place ment, it should be purged after reinstallation and
before op er at ing the tractor. See "PURGE TRANS MIS SION"
in the Operation section of this manual.
TO AD JUST STEER ING WHEEL ALIGN-
MENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 29)
• Block up axle securely.
• Remove axle cover, retaining ring and washers to allow
wheel removal.
• Repair tire and reassemble.
• Replace washers and snap retaining ring securely in
axle groove.
• Replace axle cover.
REAR WHEEL -
• Block rear axle securely.
• Remove fi ve (5) hub bolts to allow wheel removal.
• Repair tire and reassemble. Replace and tighten hub
bolts securely.
NOTE: To seal tire punctures and prevent fl at tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
WASH ERS
RE TAIN ING
RING
AXLE
COVER
24
00663
FIG. 29