How To Install The Product; Recommended Tools - Axis Q6055-S Installation Manual

AXIS Q6055-S PTZ Dome Network Camera

How to install the product

Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
NO NO TICE NO TICE TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specific use. Make sure that
the network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Regulatory information on page 32.
• Mount the product with the dome cover facing downward.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The product can be mounted with the cables routed through or along the wall or roof.

Recommended tools

NO TICE TICE
NO NO TICE
Stainless steel is corrosion-resistant, but extraneous rust can appear if the material is
handled incorrectly. Use stainless tools to avoid rust stains or pitting corrosion.
• Torx® screwdriver T10 (lid, cable clamping, media converter switch)
• Cable shoe pliers (ground cable, media converter switch)
• 7 mm wrench (ground screw, media converter switch)
• Slotted screwdriver 2.5 mm (socket, media converter switch)
• Torx® screwdriver T20 (dome cover removal)
• Torx® screwdriver T25 (dome replacement)
• 8 mm (5/16") wrench/socket (hose clamp, AXIS T91C67 Pole Bracket)
• 10 mm (3/8") wrench/socket (bracket adapter AXIS T91C61, AXIS T94S01D, AXIS T91C67
Pole Bracket)
• Diagonal pliers (cables)
• Wire stripping tool (cable connecting)
7