Table of Contents
Advertisement
Hex wrench storage
004035
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the blade making any contact. Then
turn the tool on and wait until the blade attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing slowly until the
sawing is completed. To get clear cuts, keep your
sawing line straight and your speed of advancing
uniform.
004036
Rip fence (Guide rule)
2
004037
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly against
1. Screw
2. Rip fence
1
the side of the workpiece and secure it in position with
the screw on the front of the base. It also makes
repeated cuts of uniform width possible.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
004038
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
7
1. Limit mark
1
1. Brush holder
cap
1
2. Screwdriver
2
Advertisement
Table of Contents
