Identification Of Controls; Connections; Antenna Connections; Cable Tv Connections - Toshiba SD-P4000 Service Manual

Introduction
Identification of controls (continued)
Remote control
The instructions in this manual describe the function on the remote control. See the page in
RECALL button
24
TV/DVD button
31
Direct channel selection
buttons (0-9)
23
Numbered buttons (0-9) 26
SLEEP button 24
TOP MENU button
37
SUBTITLE button
38
SETUP button 43
MENU button
21
*DVD MENU button
37
Direction buttons
21
( / / / )
CH +/- buttons
22
RETURN button
43
PLAY button
31
REV button
33
SKIP buttons
33
PAUSE button 32
SLOW buttons 33
EJECT button
32
*DVD MENU button
Use the DVD MENU button to
display the menu included on
many DVD video discs.
To operate a menu, follow the
instructions in "DVD menu."
37
12

Connections

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If
you are using a cable TV service (CABLE), see page 15 for Cable TV connections.
Combination VHF/UHF antenna (Single 75 ohm cable or 300 ohm twin-lead wire)
Antenna
Antenna
jack
jack
75 ohm coaxial cable
(not supplied)
300-75 ohm matching
transformer (supplied)
Combination VHF/UHF antenna (Separate VHF and UHF 300 ohm twin-lead wires)
Antenna
300-75 ohm matching
jack
transformer (supplied)
Combiner
(not supplied)
UHF 300 ohm
VHF 300 ohm
twin-lead wire
twin-lead wire
(not supplied)
(not supplied)
Separate VHF/UHF antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)
Antenna
jack
VHF 75 ohm
(not supplied)
Combiner
(not supplied)
UHF 300 ohm
twin-lead wire
(not supplied)
14
for details.
POWER button
21
INPUT SELECT button
16
GAME button
16
VOL +/- buttons
23
CLOSED CAPTION button
25
MUTE button
24
ZOOM button
34
CH RTN button
24
AUDIO button 30
CANCEL button
26
ENTER button 21
FWD button
33
PLAY MODE button
35
JUMP button
34
STOP button
31
REPEAT A-B button 35
ANGLE button
37
Connect the 75 ohm cable from the combination
VHF/UHF antenna to the antenna jack.
If your combination VHF/UHF antenna has a 300
ohm twin-lead wire, the use of the 300-75 ohm
matching transformer may be necessary.
Connect the UHF 300 ohm twin-lead wire to the
combiner (not supplied). Connect the VHF 300
ohm twin-lead wire to the 300-75 ohm matching
transformer. Attach the transformer to the combiner,
then attach the combiner to the antenna jack.
Connect the VHF 75 ohm cable and UHF 300 ohm
twin-lead wire to the combiner (not supplied).
Attach the combiner to the antenna jack.
Inserting batteries
1 2
Slide the battery compartment Install two "R03/AAA" batteries
(supplied), paying attention to
cover in the direction of the
arrow. the polarity diagram in the
battery compartment.
Operation
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5
meters.
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (follow battery
manufacturer's directions).

Cable TV connections

This TV/DVD has an extended tuning range and can tune most cable channels without using a Cable TV converter box.
Some cable companies offer "premium pay channels" in which the signal is scrambled. Descrambling these signals for
normal viewing requires the use of a descrambler device which is generally provided by the cable company.
For subscribers to basic cable TV service
Antenna For basic cable service not requiring a converter/descrambler
jack
box, connect the Cable TV 75 ohm coaxial cable directly to the
Antenna jack on the back of the TV/DVD.
75 ohm
coaxial cable
For subscribers to scrambled cable TV service
If you subscribe to a cable TV service which requires the use of a converter/descrambler box, connect the
incoming 75 ohm coaxial cable to the converter/descrambler box. Using another 75 ohm coaxial cable, connect
the output jack of the converter/descrambler box to the antenna jack on the TV/DVD. Follow the connections
shown below. Set the TV/DVD to the output channel of the converter/descrambler box (usually channel 3 or 4)
and use the converter/descrambler box to select channels.
Incoming
75 ohm
Cable TV
Converter/
descrambler
For subscribers to unscrambled basic cable TV service with scrambled
premium channels
If you subscribe to a cable TV service in which basic channels are unscrambled and premium channels require the
use of a converter/descrambler box, you may wish to use a signal splitter and an A/B Switch box (available from the
cable company or an electronics supply store). Follow the connections shown below. With the switch in the "B"
position, you can directly tune any nonscrambled channels on your TV/DVD. With the switch in the "A" position, tune
your TV/DVD to the output of the converter/descrambler box (usually channel 3 or 4) and use the converter/
descrambler box to tune scrambled channels.
Converter/
Incoming
descrambler
75 ohm
Cable TV
A/B switch
Splitter
3
Replace the compartment
cover.
Approx. 5 meters
13
Antenna
jack
75 ohm cable to
TV/DVD
Antenna
75 ohm cable
jack
to TV/DVD
A
B
15