Exposed Thermostatic Mixers; Installing The Thermostatic Mixer - Mira Select Flex LP-S Installation And User Manual

9.
The showerhead should be positioned so that it discharges down the centre line of the
bath or across the opening of a shower cubicle.
10. Only use the inlet connections supplied with the product. DO NOT use any other type of
fittings.
11. All pipework must be checked for leaks before the product installation is completed. The
product should be pressurised & the inlet & outlet connections inspected.
12. DO NOT overtighten connections, screws or grubscrews as product damage may occur.
13. Upon completion of installation, or if the product is dismantled during installation or
servicing, then the product must be inspected to ensure that there are no leaks.
14. Having completed the installation, make sure that the user is familiar with the operation
of the product.

Exposed Thermostatic Mixers

Installing the Thermostatic Mixer

1.
The thermostatic mixer can be installed with
rear, rising or falling supply inlets. Decide
on the most appropriate method for your
installation, and if necessary, loosen the
grubscrews and rotate the inlet elbows to suit.
Important! Make sure that the elbows are
pushed fully onto the mixer before tightening
the grubscrews, do not overtighten.
Mixer
Shower
30 mm
Minimum
25 mm Minimum
Bath or Shower
Toilet or Bidet
FC5
Zone of
Backflow Risk
25 mm
Minimum
Hand Basin
Tray FC3
FC3
9