Table of Contents
Advertisement
Operating Instructions
Troubleshooting
Error and Failure Indicator Overview
Item
COM LED
Blue LED flashes when 9433-EMDE is receiving control message from remote network control (e.g.,
DashBoard™ or Cobalt
ERR LED
This function is currently reserved.
Input Status
Three blue LEDs indicate SDI input presence and format (3G, HD, SD) of currently selected input.
LEDs
Four blue LEDs indicate presence (lock) of the four embedded audio groups on the card SDI input (GRP1,
GRP2, GRP3, GRP4).
Note: The input status LEDs may not be configured and functional on initial product release.
9433-EMDE-ADDA-OM (V1.4)
This section provides general troubleshooting information and specific
symptom/corrective action for the 9433-EMDE card and its remote control
interface. The 9433-EMDE card requires no periodic maintenance in its
normal operation; if any error indication (as described in this section) occurs,
use this section to correct the condition.
The 9433-EMDE card itself and its remote control systems all (to varying
degrees) provide error and failure indications. Depending on how the
9433-EMDE card is being used (i.e, standalone or network controlled through
DashBoard™ or a Remote Control Panel), check all available indications in
the event of an error or failure condition. The various 9433-EMDE card and
remote control error and failure indicators are individually described below.
Note:
The descriptions below provide general information for the various status and
error indicators. For specific failures, also use the appropriate subsection
listed below.
• Basic Troubleshooting Checks (p. 3-16)
• 9433-EMDE Processing Error Troubleshooting (p. 3-16)
• Troubleshooting Network/Remote Control Errors (p. 3-17)
9433-EMDE Card Edge Status/Error Indicators and Display
Figure 3-4 shows and describes the 9433-EMDE card edge status indicators
and display. These indicators and the display show status and error conditions
relating to the card itself and remote (network) communications (where
applicable). Because these indicators are part of the card itself and require no
external interface, the indicators are particularly useful in the event of
communications problems with external devices such as network remote
control devices.
Status/Error
Indicators
®
Remote Control Panel)
Figure 3-4 9433-EMDE Card Edge Status Indicators and Display
9433-EMDE-ADDA PRODUCT MANUAL
Input Status
Indicators
Function
Troubleshooting
3-13
Advertisement
Table of Contents
Troubleshooting
