Material List; Handling Precautions; General Notes - Docomo SH-03H Instruction Manual

Material list

Handset
Part
Main display
side
Sub display
side
Side surface of
main display
side
Side surface of
sub display
Surface of the
side
handset
Keyboard side UV cured resin
Side surface of
keyboard side
Back of
keyboard side
Hinge
Side surface of
hinge section
Operation key (including
ornament)
Side Key
Quick open button
Charging terminal
External connector terminal
Infrared port
Metal part
microSD Card
slot
Resin section
docomo nano UIM card tray
Sticker
Battery storage
Resin section
side
Metal part
Surrounding
area of battery
Battery storage
storage section
section
Screw
Battery terminal
connector
Battery terminal
Battery terminal Copper alloy/Gold plating
Fitting cover
Material/Surface treatment
PC, PMMA resin/Hard coating
PC, PMMA resin/Hard coating
Polyamide resin with glass/UV
coating
Aluminum/Anodizing
Polyamide resin with glass/UV
coating
PC+ABS-GF20 resin/UV coating
Polyamide resin with glass/UV
coating
ABS resin/UV coating
UV cured resin
PC resin/UV coating
PC resin
Aluminum/Anodizing
SUS/au plating
Copper alloy/Gold plating
ABS resin/Hard coating
STAINLESS
LCP
POM
PET
PC+ABS-GF20 resin
Nickel silver
PC+ABS-GF20 resin
SUS/Passivation coating
PA4T
UV cured resin
Back Cover SH75
Part
Back cover
Gasket
Battery Pack SH43
Part
Battery pack
Terminal section
Water wet determination seal
Label
Desktop Holder SH48
Part
Desktop holder (top case/bottom
case)
Terminal lever
Lock lever
Charging terminal
Metal section of connecting
terminal
Screw
Rubber base
Production lot label

Handling precautions

General notes

SH-03H is waterproof/dustproof, however, do not allow water
to get inside the handset and do not allow accessories or
optional parts to get wet.
The battery pack, adapter, desktop holder and docomo nano UIM
card are not waterproof/dustproof. Do not use in humid or steamy
areas such as bathrooms and avoid exposing to rain and other
forms of moisture. If they are carried close to the skin, perspiration
may cause internal components to corrode and result in
malfunction. Note that if a problem is found to be due to moisture,
the handset and parts are not covered by warranty and in some
cases may be irreparable. Even when repairs are possible, repair
charges will be incurred, since the damage is not covered by
warranty.
Clean only with a soft and dry cloth (such as the type used
for eyeglasses).
･
Forceful rubbing of the display with a dry cloth etc. may scratch
its surface.
･
Water drops, dirt, etc. left on the display may cause stains to
form on its surface.
･
Never use chemicals such as alcohol, thinners, benzene or
detergents, as these agents may erase the printing or cause
discoloration.
Occasionally clean terminals with a dry cotton swab etc.
Dirty terminals may result in poor connections and loss of power
or insufficient battery charge. Keep the terminals clean with a dry
cotton swab etc.
Be careful with the terminals while cleaning them.
7
Material/Surface treatment
PC+ABS-GF20 resin/UV coating
EPDM/Low friction coating
Material/Surface treatment
PC resin
Copper alloy/Gold plating
High quality paper/PET
PET/mat varnish paper
Material/Surface treatment
ABS resin/Grain finish
POM resin
POM resin
Phosphor bronze/Gold plating
SUS
Carbon steel for cold heading/
Trivalent black chromate
Foamed urethane
Polyester film
Contents/Precautions