Operating Instructions; Remote Control Instructions - Hanover X56WMEF1BLK Installation And Operation Instructions Manual

The manual controls are located on the left side of the fireplace.
LOCATION
The master power switch is located on the right side of the appliance. The control panel is on
the right corner of the glass.
MASTER SWITCH
The master switch controls the power supply to the appliance. Turn the switch to "I" to connect
power and turn the switch to "O" to cut the power. There will be a chiming sound when turning
to "I".
You have the following controls:
4

REMOTE CONTROL INSTRUCTIONS

1. Install the 2X AAA batteries in the remote control.
2. Turn the master switch on the e-fireplace to 'I' so that
it can receive the signal from the remote control.
3. Press the button 1 to change the flame
brightness, there are 5 levels ( L1 to L5). It
appears the related flame number on the
digital screen.
4.This electric fireplace is equipped with a timer
ranging from 1 hour to 9 hours. Press the timer
button 2 once for 1hour, twice for 2 hours etc.
5. CAUTION: Never leave the e-fireplace unattended
while heating.
6. Refer to above control buttons / functions for the other
buttons on the remote control.

OPERATING INSTRUCTIONS

3 2 1
1. Power ON/OFF: Touch the button once
(flame will light up) to turn power on for all
functions, Touch the button once more to
turn all functions off.
2. Press the button to change the flame
brightness, there are 5 levels ( L1 to L5).It
appears the related flame number on the
digital screen.
3. Low heat:700 watts(LO) , High heat: 1350 watts(HI)
Press the button once(the digital screen shows 'L').
Press the button a second time(the digital screen
shows 'H').
Press the button a third time to turn the heater off.
4.TIMER
Set the timer using the button (1 to 9 hours), press
button once for 1 hour increments.
RGB
The remote control uses 2X AAA batteries
1
2
NOTE: Make sure the
batteries are fully charged
and installed correctly in
your remote control.
11