Bosch HBE5452UC Use And Care Manual page 29

Refitting the appliance door
Follow the instructions in the reverse order to refit the
appliance door.
When fitting the appliance door, ensure that both
1.
hinges are inserted straight into the opening
(figure ).
!
Place both hinges at the bottom on the outer panel
and use this as a guide.
Ensure that the hinges are inserted into the correct
opening. You must be able to insert them easily and
without resistance. If you can feel any resistance,
check that the hinges are inserted into the correct
opening.
Open the appliance door fully.Close the two locking
2.
levers (figure ).
"
Close the cooking compartment door.
3.
Removing the door cover
The stainless steel insert in the door cover can discolor.
To carry out thorough cleaning, you can remove the
cover.
Open the appliance door a little.
1.
Press on the left and right of the cover (figure
2.
Remove the cover (figure
3.
Close the appliance door carefully.
Note: Clean the stainless steel insert in the cover with
stainless steel cleanser. Clean the rest of the door
cover with dishwashing detergent and a soft cloth.
Open the appliance door a little again. Put the cover
4.
back in place and press on it until it clicks audibly into
place (figure ).
#
Close the appliance door.
5.
Removing and installing the door panels
For better cleaning, you can remove the glass panels
from the appliance door.
Removing door panels from the appliance
Open the appliance door a little.
1.
Press on the left and right of the cover (figure
2.
Remove the cover (figure
3.
Undo and remove the screws on the left and right of
4.
the appliance door (fig.
!
).
"
!
).
"
# ).
).
).
29