About - CNET CWP-906 User Manual

4. Start PIN or PBC. The following procedures are as similar as section 2-7-3 (PIN Enrollee Setup) or section 2-7-4(PBC
Enrollee Setup),
5. If your AP Enrollee has been configured before the WPS process, the credential you set in advance will be updated to
the AP itself. Otherwise, after a successful registration, the AP Enrollee will be re-configured with the new parameters, and
the STA Registrar will connect to the AP Enrollee with these new parameters.
Describe "WPS Status Bar" - "PIN - xxx" as follow:
A successful PIN Configuration:
Start PIN connection - SSID -> Begin associating to WPS AP
-> Associated to WPS AP -> Sending EAPOL-Start
-> Sending EAP-Rsp (ID) -> Receive M1 ->Sending M2
-> Receive M3 -> Sending M4 -> Receive M5 -> Sending M6
->Receive M7 -> Sending M8 -> Receive EAP Rsp (Done)
-> Sending EAP Rsp(ACK) -> Configured
-> WPS status is disconnected
-> WPS status is connected successfully-SSID
Describe "WPS Status Bar" - "PBC - xxx" as follow:
A successful PBC Configuration:
Start PBC connection -> Scanning AP ->
Begin associating to WPS AP ->Associated to WPS AP
-> Sending EAPOL-Start -> Sending EAP-Rsp (ID) ->Receive M1
-> Sending M2 -> Receive M3 -> Sending M4 -> Receive M5
->Sending M6 -> Receive M7 -> Sending M8 ->
Receive EAP Rsp (Done) ->Sending EAP Rsp (ACK) -> Configured -> WPS status is disconnected ->
WPS tatus is connected uccessfully-SSID

4.2.8 About

4.2.8.1 About
Click "About" displays the wireless card and driver version information as shown in Figure 2-8.
CNet Technology Inc.
www.CNet.com.tw