Panasonic MC-BJ870 Operating Instructions Manual page 9

Anti-idling Function
The agitator will stop functioning/working when
the nozzle is lifted up for more than 5 sec.
It will restart when the nozzle is lowered onto the
floor.
- The dust sensor lamp is blinking slowly (about
3-second intervals) when the anti-idling function is
working.
- If the anti-idling function has continued for about
10 minutes, vacuum cleaner will be turn it OFF.
Changing the setting of the anti-idling
function
To cancel the anti-idling function
1
Lift the power nozzle at "AUTO" position.
- After about 5 seconds the operation is stopped,
and the dust sensor lamp is blinking slowly.
2
Press (more than 2 sec.)
(The dust sensor lamp is turned off, the setting
is completed if the operation is resumed.)
To set the anti-idling function
1
Lift the power nozzle at "AUTO" position.
2
Press (more than 2 sec.)
(The operation is stopped, the setting is
completed if the dust sensor lamp is blinking
slowly.)
Battery Status
Remaining battery level can be checked using
the following steps.
1
Remove the vacuum cleaner from the charging
base.
2
Turn on vacuum cleaner.
Battery Status Indicator
If battery status indicator is lighting then battery
power level is OK.
If battery status indicator is blinking the battery
needs to be charged before further use.
Battery Status
Indicator
Lighting
The battery is consumables.
- The run time reduces as you continue to repeatedly
use the unit. The life of the battery depends on
factors such as the ambient temperature, and
amount of time it is used, and the length of charge/
discharge cycles will become shorter depending on
usage conditions.
- If the run time reduces significantly even after
proper recharging, it means the battery has
reached the end of its service life. Please contact
to the retailer where you purchased this vacuum
cleaner.
Blinking
EN9